973SERIES ELECTRIC FLOAT LEVEL CONTROL VALVES

Product description

ARKOC ARK 973 Series electric float level control valves: Are the valves that constantly control the water level by means of the electrical float placed in the tank or reservoir. When the water level in the tank or reservoir drops below the desired value, the electrical floater sends the solenoid valve opening signal to the valve chamber to control the inlet and outlet, al-lowing the valve to fully open and start filling. When the water level reaches the maximum level, the electric floater sends the shut-off signal to the solenoid valve to allow the solenoid valve to drain into the reservoir and the valve closes itself completely and tightly.

Standard accessories

• Y-type mini strainer filter

• Mini ball valve

• Floater

• Solenoid valve

Optional accessories

• Flow regulating valve (v-port)

• Large filter

• Position indicator shaft

• Stainless or copper signal hoses according to the fluid content (chlorinated etc.)

• Stainless fittings according to the content of the fluid (chlorinated etc.)

• Stainless body

• Pressure hour

• Pressure stabilization pilot mechanism

• 4-way 3-way valve

• On-off speed adjusting valve

• mini check valve

Things to be aware of during installation and use

Before installing the valve on the pipeline, the pipeline must be free from large impurities. Absolutely dirt trap should be placed in front of the valve In case of a possible failure, an isolation valve (sliding valve or butterfly valve) must be placed in front of and behind the control valve for faster response. When mounting the valve instead of the lift ring on the should be used Must be assembled according to the arrow direction on the valve cover. Sufficient space must be left around the valve to easily make the necessary set-tings and maintenance. If the pilot mechanisms and accessories are installed on the valve, care must be taken to prevent possible damage. and it is more appropriate to remove the accessories if they can be reinstalled if possible. Valve can be installed horizontally or vertically on pipeline The electrical connections must be made with isolated and conforming cables Wires should not be creeped in places and should be laid neatly with a protective cover if necessary.